User`s guide

Using the Oscilloscope

To recover your Infiniium hard disk

The Infiniium hard disk recovery system is contained in a hidden partition on

the Infiniium hard disk. If you have to use the recovery system, the Infiniium

hard disk is returned to the condition it was in when it left the factory. Before

recovering the Infiniium hard disk, use the following procedure to return the

Infiniium to normal operation.

1 Turn off the Infiniium.

2 Turn on the Infiniium. If the oscilloscope does not successfully restart

then try recycling the power again.

3 After the Windows 7 load screen disappears, press and release the

Infiniium

[Default Setup]

key on the front panel. If the oscilloscope still

does not successfully restart, follow the instructions for recovering the

hard drive.

Infiniium Hard Drive Recovery

Use the following instructions to recover your Infiniium hard drive.

1 Turn off the Infiniium.

2 Connect the keyboard to the keyboard connector on the rear panel of

the oscilloscope.

3 Connect the mouse to the mouse connector on the rear panel of the

oscilloscope.

4 Turn on the Infiniium.

5 When you see the message press F2 to boot the Infiniium Recovery

System, press

[F2]

and follow the on-screen instructions.

6 Once the recovery process is finished and the oscilloscope is running,

check in the About Infiniium dialog box under installed options to see

if all of the options you ordered are installed. If the options are not

installed, install them using the license keys provided on the

oscilloscope option license certificates you received or on the rear

panel of the oscilloscope.