User`s guide

Using the Oscilloscope

To set the oscilloscope to trigger on an edge

1 Press and release the

[Source]

key until the desired source LED is

illuminated.

You can choose any of the channels, the Aux, or Line as the source for an edge

trigger.

2 Press the

[Slope]

key until the desired slope LED is illuminated.

You can have an edge trigger on a rising or falling edge.

3 Press the

[Sweep]

key until the Trig’d LED is illuminated.

The oscilloscope will wait for the edge before initiating a sweep.

4 Turn the

[Level]

knob to adjust the voltage level at which the oscilloscope

will trigger.