Technical data

826 Agilent Infiniium 9000 Series Oscilloscopes Programmer's Reference
28 Serial Bus Commands
:SBUS<N>:SPI:TRIGger:TYPE
Command :SBUS<N>:SPI:TRIGger:TYPE <value>
<value> ::= {MOSI | MISO}
The :SBUS<N>:SPI:TRIGger:TYPE command specifies whether the SPI
trigger will be on the MOSI data or the MISO data.
The data value is specified by the :SBUS<N>:SPI:TRIGger:PATTern:DATA
and :SBUS<N>:SPI:TRIGger:PATTern:WIDTh commands.
<N> An integer, 1-4.
Example To enable the SBUS1 trigger and set the SPI trigger type to MOSI:
myScope.WriteString ":CHANnel1:DISPlay ON"
myScope.WriteString ":CHANnel2:DISPlay ON"
myScope.WriteString ":CHANnel3:DISPlay ON"
myScope.WriteString ":CHANnel4:DISPlay ON"
myScope.WriteString ":SBUS1:MODE SPI"
myScope.WriteString ":SBUS1:SPI:WIDTh 16"
myScope.WriteString ":SBUS1:SPI:TYPE WIRE4"
myScope.WriteString ":SBUS1:SPI:SOURce:MOSI CHANnel1"
myScope.WriteString ":SBUS1:SPI:SOURce:CLOCk CHANnel2"
myScope.WriteString ":SBUS1:SPI:SOURce:FRAMe CHANnel3"
myScope.WriteString ":SBUS1:SPI:SOURce:MISO CHANnel4"
myScope.WriteString ":TRIGger:MODE SBUS1"
myScope.WriteString ":SBUS1:SPI:TRIGger:TYPE MOSI"
myScope.WriteString ":SBUS1:SPI:TRIGger:PATTern:WIDTh 2"
myScope.WriteString ":SBUS1:SPI:TRIGger:PATTern:DATA '0x0080ffff'"
Query :SBUS<N>:SPI:TRIGger:TYPE?
The :SBUS<N>:SPI:TRIGger:TYPE? query returns the trigger type setting.
Returned Format
[:SBUS<N>:SPI:TRIGger:TYPE] <value><NL>
See Also • ":TRIGger:MODE" on page 916
• ":SBUS<N>:MODE" on page 792
• ":SBUS<N>:SPI:SOURce:DATA" on page 818
• ":SBUS<N>:SPI:SOURce:MOSI" on page 821
• ":SBUS<N>:SPI:SOURce:MISO" on page 820
• ":SBUS<N>:SPI:TRIGger:PATTern:DATA" on page 822
• ":SBUS<N>:SPI:TRIGger:PATTern:WIDTh" on page 824
NOTE
You must set :SBUS<N>:MODE to SPI before you can send other :SBUS<N>:SPI:TRIGger
commands.