Technical data

Serial Bus Commands 28
Agilent Infiniium 9000 Series Oscilloscopes Programmer's Reference 803
:SBUS<N>:CAN:TRIGger:PATTern:ID:MODE
Command :SBUS<N>:CAN:TRIGger:PATTern:ID:MODE <value>
<value> ::= {STANdard | EXTended}
The :SBUS<N>:CAN:TRIGger:PATTern:ID:MODE command sets the CAN
identifier mode. STANdard selects the standard 11-bit identifier. EXTended
selects the extended 29- bit identifier. The CAN identifier is set by the
:SBUS<N>:CAN:TRIGger:PATTern:ID command.
<N> An integer, 1-4.
Query
:SBUS<N>:CAN:TRIGger:PATTern:ID:MODE?
The :SBUS<N>:CAN:TRIGger:PATTern:ID:MODE? query returns the current
setting of the CAN identifier mode.
Returned Format
<value><NL>
<value> ::= {STAN | EXT}
See Also • ":TRIGger:MODE" on page 916
• ":SBUS<N>:MODE" on page 792
• ":SBUS<N>:CAN:TRIGger" on page 798
• ":SBUS<N>:CAN:TRIGger:PATTern:DATA" on page 800
• ":SBUS<N>:CAN:TRIGger:PATTern:DATA:LENGth" on page 801
• ":SBUS<N>:CAN:TRIGger:PATTern:ID" on page 802
NOTE
You must set the proper :SBUS<N>:MODE, :SBUS<N>:CAN:TRIGger, and
:SBUS<N>:CAN:TRIGger:PATTern:ID:MODE before setting any other trigger values.