Technical data

796 Agilent Infiniium 9000 Series Oscilloscopes Programmer's Reference
28 Serial Bus Commands
:SBUS<N>:CAN:SIGNal:DEFinition
Command :SBUS<N>:CAN:SIGNal:DEFinition <value>
<value> ::= {CANH | CANL | DIFFerential | DIFL}
The :SBUS<N>:CAN:SIGNal:DEFinition command sets the CAN signal type
when :SBUS<N>:CAN:TRIGger is set to SOF (start of frame). These signals
can be set to:
Dominant high signals:
• CANH — the actual CAN_H differential bus signal.
Dominant low signals:
• CANL — the actual CAN_L differential bus signal.
• DIFL — the CAN differential (L- H) bus signal connected to an analog
source channel using a differential probe.
• DIFFerential — the CAN differential bus signal connected to an analog
source channel using a differential probe. This is the same as DIFL.
<N> An integer, 1-4.
Query
:SBUS<N>:CAN:SIGNal:DEFinition?
The :SBUS<N>:CAN:SIGNal:DEFinition? query returns the current CAN
signal type.
Returned Format
<value><NL>
<value> ::= {CANH | CANL | DIFL}
See Also • ":SBUS<N>:MODE" on page 792
• ":SBUS<N>:CAN:SIGNal:BAUDrate" on page 795
• ":SBUS<N>:CAN:SOURce" on page 797