Technical data

76 Agilent Infiniium 9000 Series Oscilloscopes Programmer's Reference
3 Introduction to Programming
Setting Up the Oscilloscope
A typical oscilloscope setup configures the vertical range and offset
voltage, the horizontal range, delay time, delay reference, trigger mode,
trigger level, and slope.
A typical example of the commands sent to the oscilloscope are:
:CHANNEL1:PROBE 10; RANGE 16;OFFSET 1.00<terminator>
:SYSTEM:HEADER OFF<terminator>
:TIMEBASE:RANGE 1E-3;DELAY 100E-6<terminator>
This example sets the time base at 1 ms full- scale (100 μs/div), with delay
of 100
μs. Vertical is set to 16 V full-scale (2 V/div), with center of screen
at 1 V, and probe attenuation of 10.