Technical data

650 Agilent Infiniium 9000 Series Oscilloscopes Programmer's Reference
25 Measure Commands
:MEASure:SETuptime
Command
:MEASure:SETuptime [<data_source>,<data_source_dir>,<clock_source>,
<clock_ source_dir>]
The :MEASure:SETuptime command measures the setup time between the
specified clock and data source.
<data_source> {CHANnel<N> | FUNCtion<F> | WMEMory<N> | CLOCk | MTRend |
MSPectrum | EQUalized}
MTRend and MSPectrum sources are only available if the oscilloscope has
the EZJIT option installed and the feature is enabled.
The CLOCk source is only available if the oscilloscope has the High Speed
Serial option installed and the feature is enabled.
The EQUalized source is only available if the oscilloscope has the High
Speed Serial option and the Serial Data Equalization option installed and
the features are enabled. This command uses the Feed- Forward Equalized
(FFE) signal as the source.
<clock_source> {CHANnel<N> | FUNCtion<F> | DIGital<M> | WMEMory<N> | CLOCk |
MTRend | MSPectrum | EQUalized}
MTRend and MSPectrum sources are only available if the oscilloscope has
the EZJIT option installed and the feature is enabled.
The CLOCk source is only available if the oscilloscope has the High Speed
Serial option installed and the feature is enabled.
The EQUalized source is only available if the oscilloscope has the High
Speed Serial option and the Serial Data Equalization option installed and
the features are enabled. This command uses the Feed- Forward Equalized
(FFE) signal as the source.
<N> CHANnel<N> is an integer, 1- 4.
WMEMory<N> is an integer, 1- 4.
<F> FUNCtion<F> is an integer, 1- 16.
<M> An integer, 0- 15. Digital channels are available on mixed-signal
oscilloscopes.
<data_source
_dir>
{RISing | FALLing | BOTH}
NOTE
This command is only available when the E2681A Jitter Analysis Software or the
N5400A/5401A Software is installed.