Technical data

Measure Commands 25
Agilent Infiniium 9000 Series Oscilloscopes Programmer's Reference 523
:MEASure:CTCJitter
Command
:MEASure:CTCJitter <source>,<direction>
The :MEASure:CYCJitter command measures the cycle- to- cycle jitter of the
waveform.
<source> {CHANnel<N> | FUNCtion<F> | WMEMory<N> | CLOCk | MTRend |
MSPectrum | EQUalized}
MTRend and MSPectrum sources are only available if the oscilloscope has
the EZJIT option installed and the feature is enabled.
The CLOCk source is only available if the oscilloscope has the High Speed
Serial option installed and the feature is enabled.
The EQUalized source is only available if the oscilloscope has the High
Speed Serial option and the Serial Data Equalization option installed and
the features are enabled. This command uses the Feed- Forward Equalized
(FFE) signal as the source.
<N> CHANnel<N> is an integer, 1- 4.
WMEMory<N> is an integer, 1- 4.
<F> FUNCtion<F> is an integer, 1- 16.
<M> An integer, 0- 15. Digital channels are only available on MSO models or
DSO models with the MSO license installed.
<direction> {RISing | FALLing}
Specifies direction of waveform edge to make measurement.
Example This example measures the cycle- to- cycle jitter on the rising edge of
channel 1.
myScope.WriteString ":MEASURE:CTCJITTER CHANNEL1,RISING"
Query :MEASure:CTCJitter? <source>,<direction>
The :MEASure:CTCJitter? query returns the cycle-to- cycle jitter time
measurement.
Returned Format
[:MEASure:CTCJitter <value>[,<result_state>]<NL>
<value> The cycle-to- cycle jitter time of the waveform.
NOTE
This command is only available when the E2681A Jitter Analysis Software or the
N5400A/N5401A Software is installed.