Technical data

488 Agilent Infiniium 9000 Series Oscilloscopes Programmer's Reference
25 Measure Commands
E2688A High
Speed Serial
Software
commands
The following MEASure commands are available when the E2688A High
Speed Serial Software is installed.
• ":MEASure:CLOCk" on page 506
• ":MEASure:CLOCk:METHod" on page 507
• ":MEASure:CLOCk:METHod:ALIGn" on page 509
• ":MEASure:CLOCk:METHod:DEEMphasis" on page 510
• ":MEASure:CLOCk:METHod:EDGE" on page 511
• ":MEASure:CLOCk:METHod:JTF" on page 513
• ":MEASure:CLOCk:METHod:OJTF" on page 515
• ":MEASure:CLOCk:VERTical" on page 517
• ":MEASure:CLOCk:VERTical:OFFSet" on page 518
• ":MEASure:CLOCk:VERTical:RANGe" on page 519
• ":MEASure:TIEData" on page 707
• ":MEASure:TIEFilter:SHAPe" on page 709
• ":MEASure:TIEFilter:STARt" on page 710
• ":MEASure:TIEFilter:STATe" on page 711
• ":MEASure:TIEFilter:STOP" on page 712
• ":MEASure:TIEFilter:TYPE" on page 713
• Also see the ":MTESt:FOLDing" on page 459 command in the mask test
system.
E2681A EZJIT
Jitter Analysis
Software
commands
The following MEASure commands are available when the E2681A EZJIT
Jitter Analysis Software is installed.
• ":MEASure:CTCDutycycle" on page 521
• ":MEASure:CTCJitter" on page 523
• ":MEASure:CTCNwidth" on page 525
• ":MEASure:CTCPwidth" on page 527
• ":MEASure:DATarate" on page 529
• ":MEASure:HOLDtime" on page 568
• ":MEASure:JITTer:HISTogram" on page 570
• ":MEASure:JITTer:MEASurement" on page 571
• ":MEASure:JITTer:SPECtrum" on page 572
• ":MEASure:JITTer:STATistics" on page 581
• ":MEASure:JITTer:TRENd" on page 582
• ":MEASure:NCJitter"
on page 589
• ":MEASure:NPERiod" on page 602