Technical data

Setting Up 2
Agilent Infiniium 9000 Series Oscilloscopes Programmer's Reference 45
Step 2. Connect and set up the oscilloscope
The Infiniium 9000A Series oscilloscope has three different interfaces you
can use for programming:
• USB (device port, square connector).
• LAN. To configure the LAN interface, set up the Infiniium oscilloscope
on the network as you would any other computer with the Windows XP
operating system.
• GPIB, when the N4865A GPIB- to- LAN adapter is used.
The 9000A Series oscilloscope is not equipped with a GPIB interface
connector.
When installed, these interfaces are always active.
Using the LAN Interface
1 If the controller PC is not already connected to the local area network
(LAN), do that first.
2 Contact your network administrator about adding the oscilloscope to
the network.
Setting up an Infiniium oscilloscope on a network is the same as setting
up any other computer with the Windows XP operating system.
3 Connect the oscilloscope to the local area network (LAN) by inserting
LAN cable into the "LAN" port on the oscilloscope.