Technical data

4 Agilent Infiniium 9000 Series Oscilloscopes Programmer's Reference
• Chapter 26, “Pod Commands,” starting on page 745
• Chapter 27, “Root Level Commands,” starting on page 751
• Chapter 28, “Serial Bus Commands,” starting on page 789
• Chapter 29, “Self-Test Commands,” starting on page 829
• Chapter 30, “Serial Data Equalization Commands,” starting on page 833
• Chapter 31, “System Commands,” starting on page 877
• Chapter 32, “Time Base Commands,” starting on page 891
• Chapter 33, “Trigger Commands,” starting on page 903
• Chapter 34, “Waveform Commands,” starting on page 1083
• Chapter 35, “Waveform Memory Commands,” starting on page 1145
Chapter 36, “Obsolete and Discontinued Commands,” starting on page
1155, describes obsolete (deprecated) commands that still work but have
been replaced by newer commands, and lists discontinued commands that
are no longer supported.
Chapter 37, “Error Messages,” starting on page 1161, describes error
messages.
Chapter 38, “Sample Programs,” starting on page 1173, shows example
programs in various languages using the VISA COM, VISA, and SICL
libraries.
Finally, Chapter 39, “Reference,” starting on page 1303, contains file
format descriptions.
See Also • For more information on using the SICL, VISA, and VISA COM libraries
in general, see the documentation that comes with the Agilent IO
Libraries Suite.
• For information on controller PC interface configuration, see the
documentation for the interface card used (for example, the Agilent
82350A GPIB interface).
• For information on oscilloscope front-panel operation, see the User's
Guide.
• For detailed connectivity information, refer to the Agilent Technologies
USB/LAN/GPIB Connectivity Guide. For a printable electronic copy of
the Connectivity Guide, direct your Web browser to "www.agilent.com"
and search for "Connectivity Guide".
• For the latest versions of this and other manuals, see:
"http://www.agilent.com/find/Infiniium- manuals"