Technical data

352 Agilent Infiniium 9000 Series Oscilloscopes Programmer's Reference
17 Function Commands
:FUNCtion<F>:MHIStogram
Command :FUNCtion<F>:MHIStogram {MEAS1 | MEAS2 | MEAS3 | MEAS4 | MEAS5}
The :FUNCtion<F>:MHIStogram command adds a Meas Histogram function
that shows a histogram of measurement values. Measurement values are
captured and the histogram is updated as new acquisitions are made.
You can display statistics for the histogram in the Measurements tab using
the :MEASure:HISTogram commands and you can get histogram statistics
using the :MEASure:HISTogram queries.
<F> An integer, 1-16, representing the selected function.
Example This example sets up a histogram function of the first measurement.
myScope.WriteString ":FUNCtion2:MHIStogram MEAS1"
See Also • ":MEASure:HISTogram:HITS" on page 555
• ":MEASure:HISTogram:M1S" on page 556
• ":MEASure:HISTogram:M2S" on page 557
• ":MEASure:HISTogram:M3S" on page 558
• ":MEASure:HISTogram:MAX" on page 559
• ":MEASure:HISTogram:MEAN" on page 560
• ":MEASure:HISTogram:MEDian" on page 561
• ":MEASure:HISTogram:MIN" on page 562
• ":MEASure:HISTogram:MODE" on page 563
• ":MEASure:HISTogram:PEAK" on page 564
• ":MEASure:HISTogram:PP" on page 565
• ":MEASure:HISTogram:RESolution" on page 566
• ":MEASure:HISTogram:STDDev" on page 567