Technical data

Agilent Infiniium 9000 Series Oscilloscopes Programmer's Reference 3
In This Book
This book is your guide to programming the Infiniium 9000 Series
oscilloscopes.
Chapter 1, “What's New,” starting on page 31, describes programming
command changes in the latest version of oscilloscope software.
Chapter 2, “Setting Up,” starting on page 43, describes the steps you must
take before you can control the oscilloscope with remote programs.
The next several chapters give you an introduction to programming the
oscilloscopes, along with necessary conceptual information. These chapters
describe basic program communications, interface, syntax, data types, and
status reporting:
• Chapter 3, “Introduction to Programming,” starting on page 51
• Chapter 4, “LAN, USB, and GPIB Interfaces,” starting on page 87
• Chapter 5, “Message Communication and System Functions,” starting on
page 99
• Chapter 6, “Status Reporting,” starting on page 103
• Chapter 7, “Remote Acquisition Synchronization,” starting on page 127
• Chapter 8, “Programming Conventions,” starting on page 137
The next chapters describe the commands used to program the
oscilloscopes. Each chapter describes the set of commands that belong to
an individual subsystem, and explains the function of each command.
• Chapter 9, “Acquire Commands,” starting on page 147
• Chapter 10, “Bus Commands,” starting on page 171
• Chapter 11, “Calibration Commands,” starting on page 181
• Chapter 12, “Channel Commands,” starting on page 189
• Chapter 13, “Common Commands,” starting on page 247
• Chapter 14, “Digital Commands,” starting on page 271
• Chapter 15, “Disk Commands,” starting on page 277
• Chapter 16, “Display Commands,” starting on page 295
• Chapter 17, “Function Commands,” starting on page 321
• Chapter 18, “Hardcopy Commands,” starting on page 367
• Chapter 19, “Histogram Commands,” starting on page 373
• Chapter 20, “InfiniiScan (ISCan) Commands,” starting on page 385
• Chapter 21, “Limit Test Commands,” starting on page 407
• Chapter 22, “Lister Commands,” starting on page 415
• Chapter 23, “Marker Commands,” starting on page 419
• Chapter 24, “Mask Test Commands,” starting on page 437
• Chapter 25, “Measure Commands,” starting on page 483