Technical data

s1
1155
Agilent Infiniium 9000 Series Oscilloscopes
Programmer's Reference
36
Obsolete and Discontinued Commands
Obsolete commands are deprecated, older forms of commands that still
work but have been replaced by newer commands.
Discontinued
Commands
Discontinued commands are commands that were used by previous
oscilloscopes, but are not supported by the Infiniium 9000 Series
oscilloscopes. Listed below are the Discontinued commands and the
nearest equivalent command available (if any).
Obsolete Command Current Command Equivalent Behavior Differences
:MEASure:CLOCk:METHod
(see page 1156)
• :MEASure:CLOCk:METHod
(see page 507)
• :MEASure:CLOCk:METHod:J
TF (see page 513)
• :MEASure:CLOCk:METHod:O
JTF (see page 515)
The command options for
specifying clock recovery PLL
options have been moved to
the new commands
:MEASure:CLOCk:METHod:JT
F and
:MEASure:CLOCk:METHod:OJ
TF.
:MEASure:DDPWS (see
page 1159)
:MEASure:RJDJ:ALL? (see
page 629)
The :MEASure:RJDJ:ALL?
query returns all of the RJDJ
jitter measurements.
Discontinued Command Current Command Equivalent Comments
:DISK:STORe ":DISK:SAVE:SETup" on
page 291
":DISK:SAVE:WAVeform" on
page 292
For saving setups and
waveforms to disk.