Technical data

Table Of Contents
Trigger Commands 33
Agilent Infiniium 9000 Series Oscilloscopes Programmer's Reference 1015
Set the Mode
Before Executing
Commands
Before you can execute the :TRIGger:ADVanced:DELay commands, set the
mode by entering:
:TRIGger:MODE ADVanced and
:TRIGger:ADVanced:MODE DELay
The ADVanced DELay commands define the conditions for the Delay
Trigger Mode. The Delay By Events Mode lets you view pulses in your
waveform that occur a number of events after a specified waveform edge.
After entering the commands above, to select Delay By Events Mode, enter:
:TRIGger:ADVanced:DELay:MODE EDLY
Then you can use the Event Delay (EDLY) commands and queries for
ARM, EVENt, and TRIGger on the following pages.
To query the oscilloscope for the advanced trigger mode or the advanced
trigger delay mode, enter:
:TRIGger:ADVanced:MODE? or
:TRIGger:ADVanced:DELay:MODE?