Technical data


55
Agilent Infiniium 9000 Series Oscilloscopes
Evaluation Guide
9
CAN
To enable CAN serial decode, your oscilloscope has to have the
CAN/FlexRay serial bus protocol option installed. (The installed
options are listed in the Help>About Infiniium... dialog.)
Make connections and perform initial setup:
1 To power the demo board, connect a USB cable between it and the
Agilent Infiniium 9000 Series oscilloscope.
You can also apply power by connecting the oscilloscope’s MSO
cable to the demo board’s 40-pin connector.
2 Connect the scope channel 1 probe to demo board CH1 and GND.
3 Turn the SELECT switch to position 8 (CAN).
4 Press [Default Setup].
5 Press [AutoScale].
Set up serial decode:
6 Choose Setup>Serial Decode....
7 In the Serial Decode dialog, select:
Then, click Auto Setup and Close.