Technical data

USB 6
Agilent Infiniium 9000 Series Oscilloscope Evaluation Guide 37
4 Connect the scope channel 2 probe to demo board D- probe loop
and GND.
5 Remove all other probes and connections.
6 If you have the MSO cable connected to the demo board’s 40-pin
connector, turn the SELECT switch to position 0 (so digital
channels aren’t captured).
7 Press [Default Setup].
8 Press [AutoScale].
You are now viewing low-speed serial traffic between a mouse and
the PC in the oscilloscope.
9 Set the time base to 20 µs/div to see a single packet.
Move the mouse and you can see additional traffic.
Set up serial decode:
10 Choose Setup>Serial Decode....
11 In the Serial Decode dialog, select:
Then, click Auto Setup and Close.