Technical data


32
Agilent Infiniium 9000 Series Oscilloscopes
Evaluation Guide
5
Mixed-Signal Oscilloscope (MSO)
In mixed analog and digital designs, it is often important to view
multiple analog and digital channels, which is significantly beyond the
capability of a 2- or 4-channel oscilloscope. With 2 or 4 oscilloscope
channels plus 16 logic timing channels, the unique 2+16 or 4+16
channel Mixed Signal Oscilloscope (MSO) affords the opportunity to
view more signals and to make time-correlated measurements across
all channels.
Make connections and perform initial setup:
1 Connect the MSO cable between the oscilloscope and the demo
board’s 40-pin connector.
This powers the demo board and probes its digital signals.
Normally, you would use flying leads to probe digital signals in
your device under test (DUT). The demo board 40-pin connector
was designed with built-in terminations.
2 Connect the scope channel 1 probe to demo board CH1 and GND.
3 Connect the scope channel 2 probe to demo board CH2 and GND.
4 Turn the SELECT switch to position 4 (DAC).
5 Press [Default Setup].
6 Press [AutoScale].