Technical data

1 Getting Started
12 Agilent Infiniium 9000 Series Oscilloscope Evaluation Guide
Horizontal Control
1 Turn the large Horizontal scale knob clockwise and
counter-clockwise to control the time/div setting of the horizontal
axis. Observe the changes in the displayed signal. The current time
base setting is displayed in the lower middle of the screen.
2 Turn the small Horizontal position knob to move the waveform
horizontally from the trigger point. Push this knob to center (zero)
the trigger point.
3 Set the time base to 1 ms/div.
4 Press the [Zoom] key.
5 Turn the
large
Horizontal
scale knob
counter-
clockwise
to make
the
window
on top
larger.
6 Press the
[Zoom]
key again
to return to the original display.
Note: At any time, to return to the original setup, press [AutoScale].
Turn to control
horizontal position
Turn to control time/div