Technical data

1 Getting Started
10 Agilent Infiniium 9000 Series Oscilloscope Evaluation Guide
Capturing and Viewing a Simple Signal
1 To power the demo board, connect a USB cable between it and the
Agilent Infiniium 9000 Series oscilloscope.
You can also apply power by connecting the oscilloscope’s MSO
cable to the demo board’s 40-pin connector.
2 Connect the scope channel 1 probe to demo board CH1 and GND.
3 Turn the SELECT switch to position 3 (Burst).
4 Press the [Default Setup] key on the front panel.
The oscilloscope is now set in the default configuration. Because
the oscilloscope may have been used in a variety of applications by
a variety of people, it is a good measurement procedure to put the
oscilloscope in a known starting mode (Default Setup). This will
make it easy to duplicate measurements as no special conditions
will be set.
Press