User`s guide

Connecting to the Device Under Test 3
InfiniiVision Oscilloscopes User’s Guide 75
Active Probes for 6000 Series 100 MHz Bandwidth Models
The following active probes use their own power supply. Therefore, they can be used on
all 6000 Series oscilloscopes, including the 100 MHz bandwidth models.
Many active probes have a 50  output impedance. The input impedance of 6000 Series
100 MHz bandwidth models is fixed at 1 M. When connecting these probes to
6000 Series 100 MHz bandwidth models, a 50  feedthrough terminator (such as Agilent
part number 0960-0301 is required).
Connect the Probes to the Oscilloscope
1 Connect the oscilloscope probe to an oscilloscope channel BNC connector.
2 Connect the probe’s retractable hook tip to the point of interest on the circuit or device
under test. Be sure to connect the probe ground lead to a ground point on the circuit.
A
CTIVE PROBES FOR ALL 6000 SERIES OSCILLOSCOPES
Active Probes Quantity Supported
1141A with 1142A power supply 4
1144A with 1142A power supply 4
1145A with 1142A power supply 2
N2772A with N2773A power supply 4
N2774A with N2775A power supply 4