User`s guide

Controls and Connectors 12
InfiniiVision Oscilloscopes User’s Guide 361
22. Measure Keys Press the [Cursors] key to turn on cursors that you can use for
making measurements. Press the [Quick Meas] key to access a set of predefined
measurements. See Chapter 6, “Measurements and Math Functions,” starting on page
191.
23. Softkeys The functions of these keys change based upon the menus shown on the
display directly above the keys.
24. Battery Status Indicators These indicators appear only on 6000A models with
option BAT (battery power). See “Power-on the Battery-Powered 6000A Series
Oscilloscope” on page 49 for important operation and safety information.
25. Power Indicator (6000L models only.) Illuminates green when power is on.
26. LAN Status Indicator (6000L models only.) This indicator illuminates green when
a LAN connection has been detected and is connected as configured. The LAN status
indicator illuminates red when the following LAN faults occur:
• failure to acquire a valid IP address
• detection of a duplicate IP address
• failure to renew an already acquired DHCP lease
The LAN status indicator flashes green when the identify function is activated (see
“Identification Function” on page 286).
27. Reset Switch (6000L models only.) When power is on, press and release this
recessed pushbutton to default LAN parameters.