User`s guide

10 Serial Decode/Lister
302 InfiniiVision Oscilloscopes User’s Guide
FlexRay Serial Decode
To set up the oscilloscope to capture FlexRay signals, see “Setup for FlexRay
Signals” on page 107.
To set up FlexRay serial decode:
1 Select the FlexRay serial decode mode:
a Press the [Acquire] key.
b Press the Serial Decode softkey.
c In the Serial Decode Menu, press the Mode softkey.
d Use the Entry knob (or repeatedly press and release the Mode softkey) to select the
FlexRay serial decode mode.
2 If the decode line does not appear on the display, press the [Serial] key to turn it on.
3 If the oscilloscope is stopped, press the [Run/Stop] key to acquire and decode data.
You can use the Zoom horizontal sweep mode for easier navigation of the decoded data.
NOTE
While decoding FlexRay data, you can use FlexRay trigger or another trigger type, such as
duration, I
2
C, Nth edge burst, sequence, SPI, or USB.
When the oscilloscope is in FlexRay trigger mode, only FlexRay decode is available.
NOTE
For FlexRay triggering setup see “FlexRay Triggering” on page 108.