User`s guide

7 Printing and Saving
258 InfiniiVision Oscilloscopes User’s Guide
System software System software files can be loaded into the oscilloscope. These
software updatescan be downloaded from:
• www.agilent.com/find/5000sw
• www.agilent.com/find/6000sw
• www.agilent.com/find/7000sw
See “Software and Firmware Updates” on page 400 for more information.
To use the file explorer
Files can be loaded and deleted using the file explorer.
You can create directories on a USB mass storage device using your PC or other
instrument. You can navigate to any directory on the USB device by rotating and pushing
the Entry knob.
1 Connect a USB mass storage device with the files to be loaded or deleted to the USB
port on the front or the rear of the oscilloscope. A small four-color circle icon may be
displayed as the USB device is read.
2 Press [Utility]&File Explorer.
3 Turn and push the Entry knob to select the desired file on the USB mass storage
device. This softkey will be labeled Press to go when pointing at a directory that can
be selected, Location when pointing to a directory that is currently selected, and
Selected when pointing to a file that can be loaded or deleted. Pressing the Entry knob
will initiate the selected activity.
NOTE
Regarding USB Ports:
The USB port on the front panel, and the USB port on the rear panel labeled “HOST” are
USB Series A receptacles. These are the receptacles to which you can connect USB
mass storage devices and printers.
The square receptacle on the rear panel labeled “DEVICE” is provided for controlling the
oscilloscope over USB. See the Programmer’s Guide for more information. To access
these documents online, direct your web browser to:
• www.agilent.com/find/5000manual
• www.agilent.com/find/6000manual
• www.agilent.com/find/7000manual