User`s guide

Printing and Saving 7
InfiniiVision Oscilloscopes User’s Guide 255
R
ECOMMENDED SIGNAL MAPPING
To save a waveform and/or setup to a USB mass storage device
1 Insert a USB mass storage device into the front or rear USB device port.
2 Press the [Save/Recall] key.
3 Press the Save softkey. The proposed file name will be shown in the “Save to file”
prompt above the Save softkey. (If you want to change the file name, press the File
Name softkey. See “Creating a new file name” on page 249 for details.)
4 Choose a file format using the Format softkey. For file format information see “Display
Image and Waveform Data File Formats” on page 250.
5 Press the Press to Save softkey.
Label Signal Scope Channel Maps to Logic
Analyzer
Channel
TxRS232 Tx Ch1 D0
RxRS232 Rx Ch2 D1
I2C Data Ch1 D0
I2C Clk Ch2 D1
SPI2 (2-wire) Clk Ch1 D0
SPI2 Data Ch2 D1
SPI3 (3-wire) ~Chip Select Ch1 D0
SPI3 Clk Ch2 D1
SPI3 Data Ch3 D2
SPI4 (4-wire) ~Chip Select Ch1 D0
SPI4 Clk Ch2 D1
SPI4 DataIn Ch3 D2
SPI4 DataOut Ch4 D3
CANDataCh1 D0
LIN Data Ch1 D0