Technical data

Using Serial Search and Navigation 13
Agilent InfiniiVision 7000B Series Oscilloscopes Evaluation Guide 69
Let’s now set up the oscilloscope to automatically search and navigate
based on specific serial search criteria. Let’s now “mark” each CAN
frame with the ID of 07F hex, and then view these frames time-correlated
with the waveform.
19 Press [Search].
20 Press Search for; then, select Data Frame ID (~RTR) to search on.
Note that all “Data Frames” based on ID = XXX (don’t care) are now
marked in orange in the left-most column. Let’s now narrow our search to
just “Data Frames” with ID = 07F hex.
21 Press Bits.
22 Press Hex; then, select “F”.
At this point we could manually scroll to these “marked” frames, or we
could use the oscilloscope’s navigation capability to automatically scroll
to and display these particular “marked” frames. Let’s use the automatic
navigation capability.
23 Press the forward key (near the [Navigate] key) multiple times to find
all of the occurrences of CAN frame 07F.
24 Press the back key to navigate back up the list.