Technical data

9 Verifying CAN Serial Bus Communication
52 Agilent InfiniiVision 7000B Series Oscilloscopes Evaluation Guide
24 Press [Mode/Coupling]; then, press Mode two times to select the
Normal trigger mode.
25 To trigger on just CAN error frames, first press [Trigger].
26 Next, select to trigger on Error Frame.
The oscilloscope should now be triggering exclusively on error frames. To
analyze transmitted data both before and after these error frames, let’s
re-scale the oscilloscope’s timebase in order to capture more frames, and
then let’s turn on the “Lister” display mode.
27 Set the timebase to 2.0 ms/div.
28 Press [Serial]; then, press Lister.
29 Next, press Lister Display to turn on the Lister display mode.