Technical data


30
Agilent InfiniiVision 7000B Series Oscilloscopes
Evaluation Guide
5
Viewing Multiple Signals in an
MCU-based Design with an MSO
In mixed analog and digital designs, it is often important to view multiple
analog and digital channels, which is significantly beyond the capability of a
typical 2- or 4-channel oscilloscope. With 2 or 4 oscilloscope channels plus
16 logic timing channels, the unique Mixed Signal Oscilloscope (MSO)
affords the opportunity to view more signals and to make time-correlated
measurements across all channels.
Setup
1 Connect the demo kit’s 40-pin ribbon cable from the back of the Agilent
InfiniiVision Series oscilloscope to the 40-pin connector on the demo
board.
2 Connect channel 1 probe to the CH1 test point and ground (GND).
3 Connect channel 2 probe to the CH2 test point and ground (GND).
4 Set the rotary switch on the demo board for the DAC signal (Mode #4).
5 Press [Default Setup].
6 Press [Auto Scale].
7 Push the Waveform Intensity knob to
automatically set the waveform
intensity to 50%.