Technical data

4 Using Pass/Fail Mask Testing to Discover a Signal Violation
28 Agilent InfiniiVision 7000B Series Oscilloscopes Evaluation Guide
13 Press Create Mask to automatically create a pass/fail mask around this
waveform.
Because the InfiniiVision oscilloscope’s mask testing capability is
hardware-based, it can test up to 100,000 waveforms/sec and provide
detailed pass/fail statistics including failure rate in terms of both percent
and a Sigma quality factor. A Sigma quality factor of 6 relates to
approximately three or fewer defects per million tested. Let’s now set up
the oscilloscope to stop on the first failure.
14 Press [Run/Stop] to stop acquisitions.
15 Press the back/up key.
16 Press Statistics.
17 Press Reset Statistics to clear the statistics from the previous test.
18 Press the back/up key.
19 Press Setup.
20 Press On Error – Stop two times.
21 Press [Clear Display].
22 Press [Run/Stop] to begin a new “Stop-on-Error” test.
Back
Back