Technical data

2 Using Auto Scale, Cursors, Measurements, and Waveform Math
20 Agilent InfiniiVision 7000B Series Oscilloscopes Evaluation Guide
14 When the popup menu closes, turn the Cursors knob to set the Y1
voltage cursor at the bottom of the channel 1 waveform.
15 Push the Cursors knob; then, turn it to select the Y2 cursor from the
popup menu.
16 When the popup menu closes, turn the Cursors knob to set the Y2
voltage cursor at the top of the channel 1 waveform. The difference in Y
cursors shows the peak-to-peak amplitude of the envelope (Y = 2.0 V).
Now that we’ve determined timing and voltage characteristics of the
channel 1 modulated waveform using “manual” cursors, let’s now
perform “tracking” cursor measurements on the channel 2 waveform.
17 Press Mode – Manual; then, select Track Waveform.
18 Press X1 Source two times to assign the X1 tracking cursor to channel 2.
19 Press X2 Source two times to assign the X2 tracking cursor to channel 2.
20 Push the Cursors knob; then, turn it to select the X1 cursor from the
popup menu.
21 When the popup menu closes, turn the Cursors knob to set the X1 cursor
at the bottom of the channel 2 waveform using the Cursors knob.
22 Push the Cursors knob; then, turn it to select the X2 cursor from the
popup menu.
23 When the popup menu closes, turn the Cursors knob to set the X2 cursor
at the top of the channel 2 waveform using the Cursors knob.