Technical data

Demo Board Getting Started Guide
10 Agilent InfiniiVision 7000B Series Oscilloscopes Evaluation Guide
Front Panel Overview
1 Run Control - When the oscilloscope
is turned on, or if [AutoScale] is
pressed, the acquisition will be set to
[Run]. At any time you may [Stop]
the acquisition process to examine a
signal in detail or to save it.
a The [Default Setup] key on the
front panel sets the oscilloscope
to the factory default
configuration.
Because the oscilloscope may have been used in a variety of
applications by a variety of people, it is a good measurement
procedure to put the oscilloscope in a known starting mode (Default
Setup). This will make it easy to duplicate measurements because no
special conditions will be set.
b The [Autoscale] key on the front panel automatically configures the
oscilloscope by analyzing all active channels, turning them on and
setting the time base, V/div, and trigger conditions for an initial
display.
c Press the [Single] key to make a single acquisition and stop the
acquisition process
2 Waveform:
a The Waveform Intensity knob
lets you set the desired signal
brightness.
b The [Acquire] key on the front
panel lets you set the
oscilloscope data acquisition
modes.