Technical data

94 7000 Series Oscilloscopes Service Guide
5 Replacing Assemblies
3 Carefully remove knobs from front panel. They may be gently
pried loose with a flat head screw driver taking care not to
scratch the faceplate, then pulled straight off.
Figure 27 Removing knobs
4 Remove bezel from front deck. Bezel is secured to front deck
by molded-in retaining clips located around the perimeter of
the bezel. Gently pry these outward (either by hand or using
a flat head screwdriver). Working your way around the bezel
releasing the clips gently lift the bezel away from the front
deck.
Figure 28 Removing the bezel
7000 service guide.book Page 94 Thursday, October 16, 2008 12:18 PM