Technical data

Service Guide 9
Figures
Figure 1. Constructing the 8-by-2 Connector 27
Figure 2. Setting Up Equipment for Digital Channel Threshold
Accuracy Test 31
Figure 3. Setting up Equipment for Voltage Measurement Accuracy
Te s t 36
Figure 4. Using a Blocking Capacitor to Reduce Noise 37
Figure 5. Setting Up Equipment for Bandwidth Verification
Te s t 40
Figure 6. Setting Up Equipment for Internal Trigger Sensitivity
Te s t 49
Figure 7. Setting Up Equipment for 2-Channel External Trigger
Sensitivity Test 52
Figure 8. Setting Up Equipment for 4-Channel External Trigger
Sensitivity Test 55
Figure 9. User Calibration cable for 2-channel oscilloscope 62
Figure 10. User Calibration cable for 4-channel oscilloscope 63
Figure 11. Example pulses 73
Figure 12. System Board Test Points - Top Side 75
Figure 13. System Board Test Points - Bottom Side 76
Figure 14. Location of the Fan Connector 80
Figure 15. Default setup screen 82
Figure 16. Removing the handle 85
Figure 17. Removing adjustable leg 86
Figure 18. Removing cabinet 87
Figure 19. Removing the rear deck assembly 88
Figure 20. Separating front and rear deck assemblies 89
Figure 21. Removing the T6 screws 90
Figure 22. TORX T10 mounting screw locations 91
Figure 23. Unlocking alignment pin 92
7000 service guide.book Page 9 Thursday, October 16, 2008 12:18 PM