Technical data

88 7000 Series Oscilloscopes Service Guide
5 Replacing Assemblies
To remove the Rear Deck Assembly
Removing the rear deck allows access to the front deck,
acquisition board, and inverter board.
1 Using a T20 TORX, locate and remove all screws securing
rear deck to front deck.
2 Remove BNC securing nuts and washers.
Figure 19 Removing the rear deck assembly
3 Carefully separate rear deck from front deck. Take care not
damage extender switch.
WARNING
Sheet metal parts may have sharp edges. Handle with care to avoid injury.
7000 service guide.book Page 88 Thursday, October 16, 2008 12:18 PM