Technical data

Troubleshooting 4
7000 Series Oscilloscopes Service Guide 71
3 Connect the power cord to the rear of the oscilloscope, then
to a suitable ac voltage source.
The oscilloscope power supply automatically adjusts for input
line voltages in the range of 100 to 240 VAC. Ensure that you
have the correct line cord (see page 105). The power cord
provided is matched to the country of origin.
• Press the power switch.
• When the oscilloscope is turned on, the front panel LEDs
will briefly light up in groups from bottom to top.
• Next the Agilent logo appear on the display.
• Next a message will appear with tips on getting started
using the oscilloscope. At this time you can press any key
to remove the message and view the display. Or you can
wait and the message will automatically disappear.
• It will take a total of about 10-15 seconds for the
oscilloscope to go through its basic self test and power-up
routine.
4 Proceed to “To verify basic oscilloscope operation” on
page 72.
WARNING
AVOID INJURY.
Always operate the oscilloscope with an approved three conductor power cable.
Do not negate the protective action of the three conductor power cable.
7000 service guide.book Page 71 Thursday, October 16, 2008 12:18 PM