Technical data

16 7000 Series Oscilloscopes Service Guide
1 Characteristics and Specifications
Transient Withstand Capability
CAUTION
Maximum input voltage for analog inputs
CAT I 300 Vrms, 400 Vpk; transient overvoltage 1.6 kVpk
CAT II 100 Vrms, 400 Vpk
with 10073C or 10074C 10:1 probe: CAT I 500 Vpk, CAT II 400 Vpk
CAUTION
Do not exceed 5 Vrms in 50 Ω mode. Input protection is enabled in
50 Ω mode, and the 50 Ω load will disconnect if greater than 5 Vrms is
detected. However, the input could still be damaged, depending on the
time constant of the signal. The 50 Ω input protection mode only
functions when the oscilloscope is powered on.
CAUTION
Maximum input voltage for logic channels:
±40 V peak CAT I; transient overvoltage 800 Vpk
7000 service guide.book Page 16 Thursday, October 16, 2008 12:18 PM