Technical data

More About Oscilloscope Commands 11
Agilent InfiniiVision 6000 Series Oscilloscopes Programmer's Guide 803
When a syntax definition specifies that a number is an integer, that means
that the number should be whole. Any fractional part will be ignored,
truncating the number. Numeric data parameters accept fractional values
are called real numbers.
All numbers must be strings of ASCII characters. Thus, when sending the
number 9, you would send a byte representing the ASCII code for the
character 9 (which is 57). A three- digit number like 102 would take up
three bytes (ASCII codes 49, 48, and 50). This is handled automatically
when you include the entire instruction in a string.
Command Tree
The command tree shows all of the commands and the relationships of the
commands to each other. The IEEE 488.2 common commands are not
listed as part of the command tree because they do not affect the position
of the parser within the tree. When a program message terminator (<NL>,
linefeed- ASCII decimal 10) or a leading colon (:) is sent to the instrument,
the parser is set to the root of the command tree.
: (root) • :ACQuire (see page 193)
• :AALias (see page 195)
• :COMPlete (see page 196)
• :COUNt (see page 197)
• :DAALias (see page 198)
• :MODE (see page 199)
• :POINts (see page 200)
• :RSIGnal (see page 201)
• :SEGMented
• :ANALyze (see page 202)
• :COUNt (see page 203)
• :INDex (see page 204)
• :SRATe (see page 207)
• :TYPE (see page 208)
• :ACTivity (see page 154)
• :AER (Arm Event Register) (see page 155)
• :AUToscale (see page 156)
• :AMODE (see page 158)
• :CHANnels (see page 159)
• :BLANk (see page 160)
• :BUS<n> (see page 210)