Technical data

800 Agilent InfiniiVision 6000 Series Oscilloscopes Programmer's Guide
11 More About Oscilloscope Commands
Instruction
Header
The instruction header is one or more mnemonics separated by colons (:)
that represent the operation to be performed by the instrument. The
"Command Tree" on page 803 illustrates how all the mnemonics can be
joined together to form a complete header.
":DISPlay:LABel ON" is a command. Queries are indicated by adding a
question mark (?) to the end of the header, for example, ":DISPlay:LABel?".
Many instructions can be used as either commands or queries, depending
on whether or not you have included the question mark. The command
and query forms of an instruction usually have different program data.
Many queries do not use any program data.
There are three types of headers:
• "Simple Command Headers" on page 801
• "Compound Command Headers" on page 801
• "Common Command Headers" on page 802
White Space
(Separator)
White space is used to separate the instruction header from the program
data. If the instruction does not require any program data parameters, you
do not need to include any white space. White space is defined as one or
more space characters. ASCII defines a space to be character 32 (in
decimal).
Program Data Program data are used to clarify the meaning of the command or query.
They provide necessary information, such as whether a function should be
on or off, or which waveform is to be displayed. Each instruction's syntax
definition shows the program data, as well as the values they accept.
"Program Data Syntax Rules" on page 802 describes all of the general rules
about acceptable values.
When there is more than one data parameter, they are separated by
commas(,). Spaces can be added around the commas to improve
readability.
Program
Message
Termin at or
The program instructions within a data message are executed after the
program message terminator is received. The terminator may be either an
NL (New Line) character, an EOI (End-Or- Identify) asserted in the
programming interface, or a combination of the two. Asserting the EOI
sets the EOI control line low on the last byte of the data message. The NL
character is an ASCII linefeed (decimal 10).
Long Form to Short Form Truncation Rules
To get the short form of a command/keyword:
NOTE
New Line Terminator Functions. The NL (New Line) terminator has the same function as
an EOS (End Of String) and EOT (End Of Text) terminator.