Technical data

702 Agilent InfiniiVision 6000 Series Oscilloscopes Programmer's Guide
7 Obsolete and Discontinued Commands
Discontinued
Commands
Discontinued commands are commands that were used by previous
oscilloscopes, but are not supported by the InfiniiVision 6000 Series
oscilloscopes. Listed below are the Discontinued commands and the
nearest equivalent command available (if any).
:MTESt:RUMode (see
page 743)
:MTESt:RMODe (see
page 389)
:MTESt:RUMode:SOFailure
(see page 744)
:MTESt:RMODe:FACTion:STO
P (see page 393)
:MTESt:{STARt | STOP} (see
page 745)
:RUN (see page 186) or :STOP
(see page 190)
:MTESt:TRIGger:SOURce (see
page 746)
:TRIGger Commands (see
page 479)
There are various commands
for setting the source with
different types of triggers.
:PRINt? (see page 747):DISPlay:DATA? (see
page 259)
:TIMebase:DELay (see
page 749)
:TIMebase:POSition (see
page 470) or
:TIMebase:WINDow:POSition
(see page 476)
TIMebase:POSition is position
value of main time base;
TIMebase:WINDow:POSition
is position value of zoomed
(delayed) time base window.
:TRIGger:CAN:ACKNowledge
(see page 750)
none
:TRIGger:CAN:SIGNal:DEFiniti
on (see page 751)
none
:TRIGger:LIN:SIGNal:DEFinitio
n (see page 752)
none
:TRIGger:THReshold (see
page 753)
:POD<n>:THReshold (see
page 407) or
:DIGital<n>:THReshold (see
page 255)
:TRIGger:TV:TVMode (see
page 754)
:TRIGger:TV:MODE (see
page 604)
Obsolete Command Current Command Equivalent Behavior Differences
Discontinued Command Current Command Equivalent Comments
ASTore :DISPlay:PERSistence INFinite
(see page 263)
CHANnel:MATH :FUNCtion:OPERation (see
page 285)
ADD not included