Technical data

Commands A-Z 6
Agilent InfiniiVision 6000 Series Oscilloscopes Programmer's Guide 685
• RX, ":TRIGger:UART:SOURce:RX" on page 619
• RXFRames, ":SBUS:UART:COUNt:RXFRames" on page 454
S • SAMPlepoint Commands:
• ":TRIGger:CAN:SAMPlepoint" on page 496
• ":TRIGger:LIN:SAMPlepoint" on page 572
• "*SAV (Save)" on page 143
• SAVE Commands:
• ":MTESt:AMASk:{SAVE | STORe}" on page 739
• ":MTESt:RMODe:FACTion:SAVE" on page 392
• ":SAVE:FILename" on page 417
• ":SAVE:IMAGe:AREA" on page 419
• ":SAVE:IMAGe:FACTors" on page 420
• ":SAVE:IMAGe:FORMat" on page 421
• ":SAVE:IMAGe:INKSaver" on page 422
• ":SAVE:IMAGe:PALette" on page 423
• ":SAVE:IMAGe[:STARt]" on page 418
• ":SAVE:LISTer[:STARt]" on page 424
• ":SAVE:MASK[:STARt]" on page 425
• ":SAVE:PWD" on page 426
• ":SAVE:SETup[:STARt]" on page 427
• ":SAVE:WAVeform:FORMat" on page 429
• ":SAVE:WAVeform:LENGth" on page 430
• ":SAVE:WAVeform:SEGMented" on page 431
• ":SAVE:WAVeform[:STARt]" on page 428
• ":SBUS:CAN:COUNt:ERRor" on page 434
• ":SBUS:CAN:COUNt:OVERload" on page 435
• ":SBUS:CAN:COUNt:RESet" on page 436
• ":SBUS:CAN:COUNt:TOTal" on page 437
• ":SBUS:CAN:COUNt:UTILization" on page 438
• ":SBUS:DISPlay" on page 439
• ":SBUS:FLEXray:COUNt:NULL" on page 440
• ":SBUS:FLEXray:COUNt:RESet" on page 441
• ":SBUS:FLEXray:COUNt:SYNC" on page 442
•
":SBUS:FLEXray:COUNt:TOTal" on page 443
• ":SBUS:I2S:BASE" on page 444