Technical data

Commands A-Z 6
Agilent InfiniiVision 6000 Series Oscilloscopes Programmer's Guide 681
• ":CHANnel<n>:OFFSet" on page 238
• ":FUNCtion:OFFSet" on page 284
• "*OPC (Operation Complete)" on page 136
• ":OPEE (Operation Status Enable Register)" on page 175
• OPERation Commands:
• ":FUNCtion:GOFT:OPERation" on page 281
• ":FUNCtion:OPERation" on page 285
• ":OPERegister:CONDition (Operation Status Condition Register)" on
page 177
• ":OPERegister[:EVENt] (Operation Status Event Register)" on page 179
• "*OPT (Option Identification)" on page 137
• ORDer, ":DISPlay:ORDer" on page 712
• OUTPut Commands:
• ":CALibrate:OUTPut" on page 223
• ":MTESt:OUTPut" on page 388
• OVERload, ":SBUS:CAN:COUNt:OVERload" on page 435
• OVERshoot, ":MEASure:OVERshoot" on page 337
• ":OVLenable (Overload Event Enable Register)" on page 181
• ":OVLRegister (Overload Event Register)" on page 183
P • PALette Commands:
• ":HARDcopy:PALette" on page 301
• ":SAVE:IMAGe:PALette" on page 423
• PARity Commands:
• ":SBUS:LIN:PARity" on page 446
• ":TRIGger:UART:PARity" on page 616
• PATTern Commands:
• ":TRIGger:CAN:PATTern:DATA" on page 492
• ":TRIGger:CAN:PATTern:DATA:LENGth" on page 493
• ":TRIGger:CAN:PATTern:ID" on page 494
• ":TRIGger:CAN:PATTern:ID:MODE" on page 495
• ":TRIGger:DURation:PATTern" on page 504
• ":TRIGger:I2S:PATTern:DATA" on page 543
• ":TRIGger:I2S:PATTern:FORMat" on page 545
• ":TRIGger:IIC:PATTern:ADDRess" on page 557
• ":TRIGger:IIC:PATTern:DATA" on page 558