Technical data

Table Of Contents

Commands by Subsystem 5

Agilent InfiniiVision 6000 Series Oscilloscopes Programmer's Guide 611

:TRIGger:UART:BAUDrate

(see page 798)

Command Syntax

:TRIGger:UART:BAUDrate <baudrate>

<baudrate> ::= integer from 1200 to 3000000 in 100 b/s increments

The :TRIGger:UART:BAUDrate command selects the bit rate (in bps) for the

serial decoder and/or trigger when in UART mode. The baud rate can be

set from 1200 b/s to 3 Mb/s in 100 b/s increments. If you enter a baud

rate that is not divisible by 100 b/s, the baud rate is set to the nearest

baud rate divisible by 100 b/s.

If the baud rate you select does not match the system baud rate, false

triggers may occur.

Query Syntax

:TRIGger:UART:BAUDrate?

The :TRIGger:UART:BAUDrate? query returns the current UART baud rate

setting.

Return Format

<baudrate> ::= integer from 1200 to 3000000 in 100 b/s increments

See Also • "Introduction to :TRIGger Commands" on page 479

• ":TRIGger:MODE" on page 485

• ":TRIGger:UART:TYPE" on page 621