Technical data

594 Agilent InfiniiVision 6000 Series Oscilloscopes Programmer's Guide
5 Commands by Subsystem
:TRIGger:SPI:CLOCk:SLOPe
(see page 798)
Command Syntax
:TRIGger:SPI:CLOCk:SLOPe <slope>
<slope> ::= {NEGative | POSitive}
The :TRIGger:SPI:CLOCk:SLOPe command specifies the rising edge
(POSitive) or falling edge (NEGative) of the SPI clock source that will
clock in the data.
Query Syntax
:TRIGger:SPI:CLOCk:SLOPe?
The :TRIGger:SPI:CLOCk:SLOPe? query returns the current SPI clock
source slope.
Return Format
<slope><NL>
<slope> ::= {NEG | POS}
See Also • "Introduction to :TRIGger Commands" on page 479
• ":TRIGger:SPI:CLOCk:TIMeout" on page 595
• ":TRIGger:SPI:SOURce:CLOCk" on page 599