Technical data

Table Of Contents

Commands by Subsystem 5

Agilent InfiniiVision 6000 Series Oscilloscopes Programmer's Guide 587

:TRIGger:SEQuence:EDGE

(see page 798)

Command Syntax

:TRIGger:SEQuence:EDGE{1 | 2} <source>, <slope>

<source> ::= {CHANnel<n> | EXTernal} for the DSO models

<source> ::= {CHANnel<n> | DIGital0,..,DIGital15} for the MSO models

<slope> ::= {POSitive | NEGative}

<n>::={1|2|3|4}forthefour channel oscilloscope models

<n> ::= {1 | 2} for the two channel oscilloscope models

The :TRIGger:SEQuence:EDGE<n> command defines the specified sequencer

edge resource according to the specified <source> and <slope>. To disable

an edge resource, set its <source> to NONE. In this case, <slope> has no

meaning.

Query Syntax

:TRIGger:SEQuence:EDGE{1 | 2}?

The :TRIGger:SEQuence:EDGE<n>? query returns the specified sequencer

edge resource setting. If the edge resource is disabled, the returned

<source> value is NONE. In this case, the <slope> is undefined.

Return Format

See Also • "Introduction to :TRIGger Commands" on page 479

• ":TRIGger:SEQuence:FIND" on page 588

• ":TRIGger:SEQuence:TRIGger" on page 592

• ":TRIGger:SEQuence:RESet" on page 590

• ":TRIGger:SEQuence:COUNt" on page 586