Technical data

Commands by Subsystem 5
Agilent InfiniiVision 6000 Series Oscilloscopes Programmer's Guide 583
:TRIGger:M1553:SOURce:UPPer
(see page 798)
Command Syntax
:TRIGger:M1553:SOURce:UPPer <source>
<source> ::= {CHANnel<n>}
<n> ::= {1 | 3}
The :TRIGger:M1553:SOURce:UPPer command controls which signal is used
as the Upper Threshold Channel source by the serial decoder and/or
trigger when in MIL- 1553 mode.
Query Syntax
:TRIGger:M1553:SOURce:UPPer?
The :TRIGger:M1553:SOURce:UPPer? query returns the currently set Upper
Threshold Channel source.
Return Format
<source><NL>
<source> ::= {CHAN<n>}
<n> ::= {1 | 3}
See Also • "Introduction to :TRIGger Commands" on page 479
• ":TRIGger:MODE" on page 485
• ":TRIGger:M1553:SOURce:LOWer" on page 582