Technical data

Commands by Subsystem 5
Agilent InfiniiVision 6000 Series Oscilloscopes Programmer's Guide 525
:TRIGger:FLEXray:FRAMe:ID
(see page 798)
Command Syntax
:TRIGger:FLEXray:FRAMe:ID <frame_id>
<frame_id> ::= {ALL | <frame #>}
<frame #> ::= integer from 1-2047
The :TRIGger:FLEXray:FRAMe:ID command sets the FlexRay frame ID to
trigger on . The frame IF setting is only valid when the FlexRay trigger
mode is set to FRAME.
Query Syntax
:TRIGger:FLEXray:FRAMe:ID?
The :TRIGger:FLEXray:FRAMe:ID? query returns the current frame ID
setting for the FlexRay frame trigger setup.
Return Format
<frame_id><NL>
<frame_id> ::= {ALL | <frame #>}
<frame #> ::= integer from 1-2047
See Also • "Introduction to :TRIGger Commands" on page 479
• ":TRIGger:MODE" on page 485
• ":TRIGger:FLEXray:TRIGger" on page 528
NOTE
This command is only valid when the FLEXray triggering and serial decode option (Option
FLX) has been licensed.