Technical data

Table Of Contents

470 Agilent InfiniiVision 6000 Series Oscilloscopes Programmer's Guide

5 Commands by Subsystem

:TIMebase:POSition

(see page 798)

Command Syntax

:TIMebase:POSition <pos>

<pos> ::= time in seconds from the trigger to the display reference

in NR3 format

The :TIMebase:POSition command sets the time interval between the

trigger event and the display reference point on the screen. The display

reference point is either left, right, or center and is set with the

:TIMebase:REFerence command. The maximum position value depends on

the time/division settings.

Query Syntax

:TIMebase:POSition?

The :TIMebase:POSition? query returns the current time from the trigger to

the display reference in seconds.

Return Format

<pos> ::= time in seconds from the trigger to the display reference

in NR3 format

See Also • "Introduction to :TIMebase Commands" on page 468

• ":TIMebase:REFerence" on page 473

• ":TIMebase:RANGe" on page 471

• ":TIMebase:SCALe" on page 474

• ":TIMebase:WINDow:POSition" on page 476

• ":TIMebase:DELay" on page 749

NOTE

This command is an alias for the :TIMebase:DELay command.