Technical data

Table Of Contents

Commands by Subsystem 5

Agilent InfiniiVision 6000 Series Oscilloscopes Programmer's Guide 405

:POD<n>:DISPlay

(see page 798)

Command Syntax

:POD<n>:DISPlay <display>

<display> ::= {{1 | ON} | {0 | OFF}}

<n> ::= An integer, 1 or 2, is attached as a suffix to the command and

defines the group of channels that are affected by the command.

POD1 ::= D0-D7

POD2 ::= D8-D15

The :POD<n>:DISPlay command turns displaying of the specified group of

channels on or off.

Query Syntax

:POD<n>:DISPlay?

The :POD<n>:DISPlay? query returns the current display setting of the

specified group of channels.

Return Format

<display> ::= {0 | 1}

See Also • "Introduction to :POD<n> Commands" on page 404

• ":DIGital<n>:DISPlay" on page 251

• ":CHANnel<n>:DISPlay" on page 234

• ":VIEW" on page 192

• ":BLANk" on page 160

• ":STATus" on page 189

NOTE

This command is only valid for the MSO models.