Technical data

Commands by Subsystem 5
Agilent InfiniiVision 6000 Series Oscilloscopes Programmer's Guide 211
Introduction to
:BUS<n>
Commands
<n> ::= {1 | 2}
The BUS subsystem commands control the viewing, labeling, and digital
channel makeup of two possible buses.
Reporting the Setup
Use :BUS<n>? to query setup information for the BUS subsystem.
Return Format
The following is a sample response from the :BUS1? query. In this case,
the query was issued following a *RST command.
:BUS1:DISP 0;LAB "BUS1";MASK +255
NOTE
These commands are only valid for the MSO models.