Technical data

160 Agilent InfiniiVision 6000 Series Oscilloscopes Programmer's Guide
5 Commands by Subsystem
:BLANk
(see page 798)
Command Syntax
:BLANk [<source>]
<source> ::= {CHANnel<n> | FUNCtion | MATH | SBUS} for the DSO models
<source> ::= {CHANnel<n> | DIGital0,..,DIGital15 | POD{1 | 2}
| BUS{1 | 2} | FUNCtion | MATH | SBUS} for the MSO models
<n>::={1|2|3|4}forthefour channel oscilloscope models
<n> ::= {1 | 2} for the two channel oscilloscope models
The :BLANk command turns off (stops displaying) the specified channel,
digital pod, math function, or serial decode bus. The :BLANk command
with no parameter turns off all sources.
See Also • "Introduction to Root (:) Commands" on page 153
• ":CDISplay" on page 161
• ":CHANnel<n>:DISPlay" on page 234
• ":DIGital<n>:DISPlay" on page 251
• ":FUNCtion:DISPlay" on page 280
• ":POD<n>:DISPlay" on page 405
• ":STATus" on page 189
• ":VIEW" on page 192
Example Code • "Example Code" on page 192
NOTE
To turn on (start displaying) a channel, etc., use the :VIEW command. The DISPlay
commands, :CHANnel<n>:DISPlay, :FUNCtion:DISPlay, :POD<n>:DISPlay, or
:DIGital<n>:DISPlay, are the preferred method to turn on/off a channel, etc.
NOTE
MATH is an alias for FUNCtion.